Coriolis mass flow meter provider today: Common Types: Common types of mass flow meters include thermal mass flow meters, Coriolis mass flow meters, and gravimetric flow meters. What is volumetric flow meter? Measures Volume Flow: Volumetric flow meters measure the volume of fluid flowing through a pipe or conduit over a given period of time. They are typically measured using cubic meters per second (m3/s) or other volume-related units. Because volumetric flow meters measure volume directly, they are sensitive to changes in temperature and pressure. When the temperature or pressure of the fluid changes, the volume of the fluid changes. See more details on https://www.bjssae.com/v-shape-coriolis-mass-flow-meter-video.html.
Influence of humidity on measurement results when using vortex meter. The output of the vortex flowmeter is only proportional to the flow velocity of the fluid flowing through the measuring tube. When measuring wet saturated steam, the influence of water droplets on the output of the turbine flow meter is negligible, so it can be considered that the output of the turbine flow meter is entirely caused by the wet flow. Caused by the dry part of the steam. The density of the dry part, whether it is pressure compensation or temperature compensation, can be detected more accurately. The results of steam measurement are often used as the basis for economic settlement between the supply and demand sides. If the two parties agree to settle the fee according to the dry part of the steam and no charge for the condensed water, the impact of the phase change on the measurement is negligible and can be ignored.
After-sales service of gas turbine flowmeter: The use effect of gas turbine flowmeter largely depends on whether it is used reasonably. For new users, it is the supplier’s responsibility to provide technical guidance before the user installs. As for the products of international brands, they have occupied the market of major Chinese users for many years, and these major users have sufficient technical strength. For their scattered users, they basically rely on middlemen to do it. Problems brought about by after-sales service appear.
Thermal mass flow meters are suitable for all industrial and test platform applications that require fast, accurate gas measurement. The insertion thermal mass flow meter directly indicates the mass flow or standardized volume flow of the gas without any additional pressure and temperature compensation. They have impressive high accuracy, short response times and a very wide flow range, with almost no loss of accuracy even at the lowest flow. Read additional information at https://www.bjssae.com/.
Beijing Sincerity Automatic Equipment Co., Ltd was reformed from the Petrochemical Branch Automatic Equipment Co.,Ltd. Beijing Sincerity is the innovation developed enterprise invested by both the China Petroleum &Chemical Corporation’s Beijing Research Institute of Chemical Industries and the Capital Science and Technology Group. Please be noticed, that all the videos taken are approved by SGS, Switzerland, or TUV, Germany. All the videos are real and without shooting skills or beauty filters.
In the flow calculator, the mass flow rate can be calculated according to the temperature and pressure of the superheated steam, but when the superheated steam is transported for a long distance, or due to improper insulation measures of the pipeline, the temperature will often drop due to heat loss. The superheated state enters the critical saturation state, and even part of the steam condenses and undergoes a phase change and turns into water droplets. At this time, it becomes wet saturated steam.
The Insertion Density Meters are equiped with the microprocessors inside, so the sensor could complete the signal conditioning, calculation and diagnosis functions, and it does not need the remote eletronic devices for processing. Typical industries applied include the petrochemical industiry, electricity power industry, wine industry, food industry, pharmaceutical industry, and mineral processing (such as, clay, carbonate, silicate, etc. ) For sepecific applications, the Insertion Density Meters are largely used in the interface detection of the multi-product production lines, density detection of the mixed liquid, end monitoring of the reaction kettle, and the separator interface detection.